ITEM WIRE COLOR POL WIRE LOCATION 
12V red/Grn & red/Blu + ignition harness 
STARTER black/blue + ignition harness 
IGNITION green + ignition harness 
SECOND IGNITION purple + ignition harness 
POWER LOCK blue/red - 54 pin plug, pin #22 @ *1 
POWER UNLOCK white/black *3 - 54 pin plug, pin #20 @ *1 
PARKING LIGHTS + *4 
DOOR TRIGGER red/blue + 54 pin plug, pin #18 @ *1 
DOME SUPERVISION comes on with unlock 
TRUNK/HATCH PIN white/brown - drivers kick panel 
HOOD PIN purple/green - 26 pin plug, pin #7 @ *1
TRNK/HTCH RELEASE gray/green + 54 pin plug, pin #17 @ *1
FCTRY ALARM ARM arms with lock 
FCTRY ALRM DISARM disarms with unlock 
TACHOMETER black diagnostic plug *2 
BRAKE WIRE brown/white + brake pedal switch 
HORN TRIGGER purple/blue + horn relay *5 
WINDOWS |*6 

NOTE: This vehicle is equipped with the EWS II immobilizer system that need to be bypassed when adding a remote start. Use DEI module 555B and refer to DirectFax document #1056 for
additional wiring information.
*1 The general module is a white box located behind the glove box. The 54 pin plug is the center plug, and the 26 pin plug is the one on the left.
*2 The diagnostic plug is on the passengers side of the engine compartment.
*3 On some models, unlock may require a double pulse.
*4 Need to remove the light switch module from the dash and pop off the front cover. A ribbon cable which connects the switch to the module will be exposed. With the switch facing towards
you, you need to interrupt the fourth wire from the left with a relay. When interrupted the parking lights will come on. See DirectFax document # 1055 for wiring information.
*5 The horn relay is above the general module. It is the green relay to the right of an orange relay.
*6 Extended triggers on the door lock wires will roll the windows up/down and open/close the sunroof. Use validity channels to control.