For the Following Harnesses:

BT1722, BT7903, BT8901, BT9003, BT9220, BTJAG

You WILL Need to Reverse the Parrot Fuse Holders Before Installation.

In most vehicles, the 12v constant and the 12v switched ignition wires are reversed for purposes of a Parrot kit installation.

Simply reverse the tops of the two parrot fuse holder tops of the two fuse holders so that RED goes to Orange and Orange goes to RED.

If you do not swap these fuse tops, your unit may not turn on or off, or you may not get the Goodbye message when you shut off your vehicle.

After installation, verify that it has been doen correctly by seeing the "Goodbye" message upon turning off your vehicle.

GMCSS-1 GMCSS-2, FCSS-1, FCSS-2

Parrot1
The parrot 1 has been designed to be used in conjunction with the FCSS and GMSS. The newer harness has Motorola connectors which mate with the connectors on the parrot1

Parrot 3000
Use the parrot1 as is, plug and play.

Parrot 3100/3300
These two kits have a line (low) level output, two separate wires coming off the kit.
Trim the large brown connector off the Parrott-1.
Butt splice the Parrot wire harness low level output positive lime green ( or white wire ) wire to the blue wire that runs to the small micofit connector.
Now butt splice the other low level out negative light brown to the green wire the runs to the small microfit connector.
Plug orange mute to Yellow mute lead on the parrot kit.

Parrott 3200
Cut the brown plug off of the Parrot1 harness and connect
The white wire from the Parrot harness to blue wire on the Parrot1.
The brown wire from the Parrot harness to green wire on Parrot1
Plug orange mute to Yellow mute lead on the parrot kit.